Skip to content
Back to Use & Care

Preheating

Preheating

Give it a minute.

A few minutes · Every time you cook

Cast iron takes a little longer to warm through. Start over low to medium heat, give your Ironclad a few minutes, then add your oil and food.

What You’ll Need

  • Ironclad
  • A stovetop
  • A little oil
  • Whatever you’re cooking

Method

  1. Put your Ironclad over low heat for a minute or two to start warming.Setting the hob to low heat under the empty pan
  2. Turn it up to the cooking heat your recipe needs.Turning the hob up to cooking heat
  3. Give the iron time to reach cooking temperature, then add a little oil and let it warm.Adding a drop of water to the panA drop of water sitting still on the panThe drop of water sizzling and moving on the hot panPouring oil into the hot pan
  4. For frying or searing, the oil should flow easily across the surface. If it starts to smoke, turn the heat down.
  5. Add your ingredients.Two steaks searing in the panLifting a steak to check it has brownedA browned steak releasing cleanly from the pan

Good to Know

Preheating will make the food taste better and your Ironclad last longer.

Give the iron a minute or two on low heat before turning it up, especially on induction. Induction is power. And power is powerful. Taking iron from cold to blasting hot can cause warping.

Preheating is a good habit with any cookware.

Once your Ironclad is warmed through, turn it up to the desired heat and let it get hot before adding oil and ingredients.

A hot pan cooks well. Food browns more evenly, sticking is less likely, steaks release cleanly, and the temperature drops less when you add new ingredients, giving you more control during cooking and more predictable results at the table.

A Junior, an Old Dutch and a Takumi Wok will not warm at the same speed. Use a cooking zone that suits the base and give the iron time to heat through. If your cooktop does not recognise a small pan, check its minimum base size.

For the Takumi Wok, match the cooking zone to its flat base rather than the width of the bowl. Give the heat time to reach the curved sides.